HP C2233 Product Description Manual page 27

Mounting
Information
Safety IRegulatory
Considerations
Chassis Dimensions
and Mounting Screw
Locations
Connector
Dimensions and
Locations
Physical Mounting
DRAFT
10/24/90 12:44
Since each design installation of the product can be
unique, the following information should be taken into
consideration when mounting the product. The disk drive
can be mounted in any of the major mounting axes. Refer
to Figure 2-2.
• When installing an HP C2233/34/35 Disk Drive into
an end use product, safety and regulatory conditions of
acceptability should be considered.
• If the front bezel option has been installed, it should be
evaluated in the intended end use application.
The physical dimensions and mounting screw locations
for the disk drive are shown in figure 2-2. The length
dimensions shown do not include clearances for power and
interface connectors.
The physical locations and dimensions of the disk drive
connectors are shown in figure 2-3.
Typically, the disk drive is fastened directly to a chassis
with four no. 6-32 screws. There are twelve (12) threaded
mounting holes (for no. 6-32 screws) on the disk drive:
four on each side, and four on the bottom (see figure 2-2).
Use the following guidelines to mount the disk drive:
• Use 6-32 screws and torque them to 20 inch-pounds.
• When mounted, the hardware should not protrude more
than 3 mm (0.12 in.) beyond the inside of the disk drive
frame.
Product Installation 2·5