Led / Valet Pod & System Wiring Diagram; Car Jack Protection Features - CrimeStopper CS-2002DPII Installation And Operating Instructions Manual

Remote control alarm system
Table of Contents

Advertisement

FULL-TIME CARJACK
ONLY USE THIS MODE WHEN THERE IS AN EXTREME TREAT OF A CARJACK WITH YOUR VEHICLE. Full-time Carjack
protection must be enabled before use through Alarm programming options (13) & (14). See page 10. EVERY TIME the Ignition
is turned ON or a door is opened and closed with the Ignition ON, a Carjack countdown sequence will be initiated. 90 Seconds
later, the unit will begin a Carjack Cycle consisting of 20 seconds of pre-warning chirps turning into a full system activation with
siren/flashing light pulses for 5 min. You must reset the unit every time the IGNITION is turned on or a door is opened and
closed when the ignition is on. To reset Ignition must be ON, doors must be closed, then press override/program button (3)
times.
NOTE: When FULL TIME CARJACK is in effect, it must be reset every time the key is turned on, Door is opened, before
entering VALET mode, and before Programming options or transmitters! It is always in effect each time the Ignition is
turned on and/or a door is opened with Ignition on! If power becomes disconnected, then re-connected the Carjack
Full-time carjack trigger will be active. Press the override button 3 times with the Key on the doors closed to reset.
LED / VALET BUTTON POD:
LED POD
VALET/PROGRAM
BUTTON
CARJACK PROTECTION FEATURES
LED / VALET POD OPERATION & MOUNTING
SYSTEM
LED
Use
"L" Bracket
LED / VALET BUTTON POD MOUNTING:
UNDER
DASH
18
IN DASH
OR

Advertisement

Table of Contents
loading

Table of Contents