CrimeStopper CS-2002DPII Installation And Operating Instructions Manual page 11

Remote control alarm system
Table of Contents

Advertisement

OPTION PROGRAMMING
1. HORN CHIRPS / PULSES
This option controls the system's Factory Vehicle Horn output. There are 3 selections: Button 1 (Lock) = Horn Pulse
only when alarm is tripped. Button 2 (Unlock) = Horn Chirps for Arm / Disarm and Pulse when tripped. Button 3
(Trunk) = Horn Chirps for Arm, Disarm, and Pre-warning protection. All settings provide horn pulses when triggered.
2. PASSIVE ARMING / CHIRP COUNTDOWN
This option controls the Passive (Automatic) Arming feature. If ON, arming will occur 30 Seconds after the ignition is
turned off and the last door has been closed. The LED will begin flashing rapidly while counting down. If a door is
reopened, the system will wait for the door or zone to close before arming. The unit will flash the lights once. Doors
will lock if passive locking is selected. Factory default setting is OFF. If Passive Chirp countdown is selected, the
System will produce a siren chirp every 2 seconds as soon as the last door is closed until the system arms 30 seconds
later. Note: If you re-enter the vehicle you must turn ignition key ON and OFF for passive arming to reactivate.
3. PASSIVE LOCKS / CUSTOM OVERRRIDE (ALSO SEE CUSTOM OVERRIDE SECTION, PAGE 13)
This option controls whether the doors will lock when Passive Arming occurs. Note: May increase the risk of locking
keys in the vehicle. When selected ON the alarm will passively lock the doors when passive arming.
4. IGNITION-CONTROLLED LOCKS
This option controls whether the locks are controlled by Ignition. There are 3 selections: Button 1 (Lock) = Lock/Unlock
with vehicle Ignition. Button 2 (Unlock) = No ignition locks. Button 3 (Trunk) = Ignition lock only. Doors will not lock if
they are open to prevent locking the keys in.
5. DOOR OPEN WARNING (5 or 60 Seconds)
This setting changes the delay time in which the alarm system begins to monitor the Door circuit. This option can
prevent the alarm from giving warning chirps on vehicles with a delayed dome light.
6. ACTIVE RE-ARMING
Active Re-arming allows the system to re-arm itself 30 seconds after disarmed with the transmitter if a door has not
been opened. This is handy if the vehicle is accidentally disarmed (via the Transmitter in your pocket) without you
knowing it. Note: Active re-arm is reset by dome light illumination. If you are using dome light illumination, active re-
arm will not function.
11

Advertisement

Table of Contents
loading

Table of Contents