Table of Contents
Advertisement
5.10 Accessories
This section illustrates several accesory kits available at
the time of print. Obtain the latest accessory information
from your authorized distributor/dealer.
Follow the installation and operation instructions
provided with the accessory kit. Run AC and DC wiring
in separate conduit. Observe all national, state and local
codes during accessory installation.
5.10.1 Relay and Harness Accessory Kit
A relay accessory kit is available for model
REODB/REOZDB generator sets. The kit is required for
output connection to customer-provided devices. Do
not connect directly to the terminals on the back of the
controller.
The kit includes an interconnection harness and three
auxiliary relays, which allow the following connections:
D
Remote start/stop switch or automatic transfer switch
D
A Modbus device such as the Remote Serial
Annunciator
D
Generator running output
D
Common fault 1 and 2 outputs
The run relay provides a generator set running output.
Two common fault relays provide the connection points
for the common fault 1 and common fault 2 outputs.
Normally open and normally closed contacts are
provided to trigger customer-provided devices if a
selected fault or event occurs. Assign faults and events
to the common fault outputs using the KPC 1000
controller. See the Operation Manual.
Refer to Figure 5-4 and the accessory interconnection
diagram in Section 7 for connections.
TP-6609 6/08
Relay Internal Wiring:
1. Junction box
2. Relays (qty. 3)
3. Interconnection harness
Figure 5-4 Run/Common Fault Relay Kit
1
2
3
GM62882
Section 5 Electrical System
39
Advertisement
Table of Contents
