6. Marking ............................. 7 7. Safety technique ..........................8 8. Installation of SGC ..........................9 GENERAL INFORMATION ABOUT THE DEVICE 9. Switching on and setting up of SGC ..................... 10 Device name: 10. Replacing the frame with a mesh ....................12 Manufacturing company: 11.
60 kg 220/380V, 50 Hz Installation of SGC is possible both as an additional unit for a series of ADS grain cleaners, and as a separate unit as well. It allows operation in closed areas, granaries, in the conditions of elevators, as well as in factories 3.
The operation of the unit consists in separating the grain from the rest according to the given A plate is attached to the outer surface of each SGC: size during its passage through the calibration mesh. At first, the grain is fed to the upper part...
• Install SGC at the place of further operation. performed only by certified specialists! • During the installation of SGC on ADS grain cleaners, SGC is installed on top of the receiving hopper, using loops depending on the model of the separator.
• In this mode, with the correct configuration, the SGC can discard up to 60% of waste from the source material, depending on the quality of the material being fed. The operation of the SGC in this mode allows the cleaned material to be fed into the tray for the removal of calibrated material.
• Check the correct installation of the frame with the mesh and the reliability of fastening the mechanisms; • Before sending the SGC for storage or preservation, it is necessary to clean the SGC, check the reliability of the fastening of the moving parts and mechanisms of the SGC, •...
The decision to accept SGC is transported by road or rail transport in accordance with the rules of cargo a defective product for repair is made by a service employee of the manufacturer’s plant transportation.
SGC should be stored in a dry, ventilated room. It is impossible to allow atmospheric precipitation and foreign objects to enter. The manufacturing company is not responsible for the correct and safe operation of the machine, if the rules of operation and storage of the machine have been violated.