Table of Contents
Advertisement
Correcting the date
Switch the power on.
1. Depress the DATE button for 3 seconds,
the "Year" digits and
will blink.
2. Each time the DATE button is depressed,
the blinking digits changes in the follow¬
ing manner:
Year - Month - Day - Time - Minutes
Stop depressing the button when desired
digits appear.
3. Move the zoom lever to the right or left,
when you wish to change the blinking dig¬
its. The digits increases by one each time
the lever moves to the right and the digits
decrease by one each time the lever
moves to the left. Holding the zoom lever
for about one second will change the dig¬
its continuously.
4. After the data has been adjusted, depress
the DATE button repeatedly until blinking
stops.
• The blinking "minutes" allows precise fine-tun¬
ing of the internal clock to the beginning of a
specified minute. To do so, when "minutes dig¬
its" are blinking, depress the DATE button in
sync with a time signal.
• If you release the shutter while the blinking
data is being corrected, the data cannot be
imprinted.
Operational precautions
• The data on the LCD panel is Imprinted on
each frame you expose.
• "Year-Month-Day" and "Day - Hour - Minute"
cannot be imprinted at the same time.
• The dating unit automatically switches the
imprint mode between the standard and
panorama according to the format mode
selected,
• If there is a white or yellow object in the corner
of the picture where the data is imprinted, the
data may be difficult to read. When composing
your photographs, try to avoid brightly-colored
subjects in that corner.
41
Advertisement
Table of Contents
