Advertisement
CONNECTING INSTRUCTIONS
TAPE DECK CONNECTION
Recording
Playback
DIN CONNECTOR (REC/PLAY CONNECTOR)
TURNTABLE CONNECTION
AC OUTLETS
TUNER CONNECTION
1.
2.
AUX (AUXILIARY INPUTS)
Notes:
A tape deck can be connected for playback as follows: left chan
nel output of the tape deck to TAPE A "L" PLAY jack, right channel
output of the tape deck to TAPE A "R" PLAY jack.
f an additional tape deck is used and two tape decks are operated
simultaneously, the same connections must be provided for TAPE B
jacks.
The AC outlets on the rear panel of the amplifier may be used to
supply power to other components, such as a turntable, tape deck, etc.
SW TCHED outlets
These outlets are controlled by the POWER switch on the front
panel. (The total capacity is 100 watts maximum.)
UNSW TCHED outlet
This outlet delivers power at all times. (The capacity is 200 watts
maximum.)
1. The AC OUTLETS are used for AUD O units only. Units of the great capacity
should not be absolutely connected.
2. Units shipped to the European countries are not equipped with the AC OUTLETS.
KA 35OCKK) 5
A tape deck can be connected for recording as follows: left chan
nel input of the tape deck to TAPE A "L" REC jack, right channel
input of the tape deck to TAPE A "R" REC jack.
f your tape deck is equipped with a D N connector, connect it to
the "TAPE A" REC/PLAY connector with a D N connecting cord.
AD N connector enables recording and playback with this single cord.
Note: When a D N cord is used for connecting to the tape deck, the PLAY and REC jacks
should not be used.
Sound cannot be heard when the SPEAKERS switch on the front
panel is set to the A+B position and only one pair of speaker system
is used with connections made either to "A" speaker terminals or "B"
speaker terminals.
When connecting the speaker leads to the speaker
terminals, make sure that the bare wire strands at the ends of the
speaker leads don't touch each other or adjacent terminal.
Use the TUNER terminals for connection to an FM stereo or
AM-FM stereo tuner.
Connect the left channel of the tuner to the "L" TUNER input
jack and the right channel of the tuner to the "R" TUNER input jack.
The two shielded audio cables from your stereo turntable are
normally terminated with phono plugs. Connect the left channel of
the turntable to the "L" PHONO input jack and the right channel to
the "R" PHONO input jack.
f the turntable has a grounding wire, connect it to this amplifier's
GND terminal to avoid hum.
High level AUX input jacks are for miscellaneous sources, such as
extra tape decks, additional tuners and/or receivers, TV sound outputs,
and other external components.
SPEAKER CONNECTING AND SPEAKER SWITCH
n connecting only one set of speakers, connect the right speaker
to right speaker terminals and left speaker to left speaker terminals of
"A" speaker terminals.
Should plus or minus of either right or left
channel be reversely connected, sounds at the center section will be
adversely affected by lack of separation. To connect additional set of
speakers, connect right speaker to right speaker terminals and left
speaker to left speaker terminals of "B" speaker terminals.
Advertisement
