Table of Contents
Advertisement
The Stitch produced when sewing must be exactly the same
as that engraved on the Cam 107.
If this is not the case, adjust as follows:
Slightly loosen the Set Screw on the reversing lever support.
This will free the Adjusting Screw for making the following
adjustment.
The material was fed too fast, creating a long stitch.
Turn Adjusting Screw slightly Counterclockwise.
The material was fed too slow, creating a short stitch.
Turn Adjusting Screw slightly Clockwise.
Tighten the Set screw firmly after this adjustment.
Sew another sample to verify the results of this adjustment.
Readjust until the design obtained when sewing is exactly the
same as that engraved on the Cam 107.
26
Hide quick links:
Advertisement
Table of Contents
