6. Timing of Shuttle Hook in relation to Needle Bar
If timing of shuttle hook in relation to needle bar is correct,
the point of the shuttle hook must be behind the center of
the needle after the needle bar has risen 2.25 mm [.089"]
from its lowest position.
(For this test, the Centering Dial must be in the center
position and stitch width knob at "0.")
If this requirement is not met, adjust as follows:
Remove needle, presser foot, needle plate and feed dog. Open shuttle cover.
Removing the Upper and Lower Guard Rings
Remove the 2 Spring Screws which hold upper guard ring to
lower guard ring.
Do not remove the two screws which hold the Shuttle Beak
to the upper guard ring.
Lift Upper Guard Ring from shuttle assembly.
Turn flywheel slowly toward you until the opening in the
Shuttle Hook faces towards the back of the machine.
With a finger, turn the Lower Guard Ring inside of shuttle
hook until the straight edge of the lower guard ring is aligned
with the edge of the shuttle hook opening.
Pull out lower guard ring through the opening in the shuttle
hook.
Loosen slightly the three screws at the bottom of the shuttle
hook until the shuttle hook can be turned with slight friction.
Do not remove oil hole screw in center of shuttle hook!
12