Table of Contents
Advertisement
During quick timer recording
The display window shows the remaining recording time.
To stop the quick timer recording
Press the TIMER REC ON/OFF button.
The recording stops and the recorder will be turned off after about
30 seconds.
ONCE THE QUICK TIMER RECORDING HAS STARTED
No function button except for the following will activate :
QUICK TIMER button ... to change the recording time
CHECK button. . .to check the contents of the preset timer
programs
TIMER REC ON/OFF button ... to stop recording
PAUSE button ... to stop the tape momentarily
Notes
When the quick timer recording overlaps the preset timer program
The quick timer recording is continued prior to the timer program.
The QUICK TIMER button does not function while the TIMER REC
lamp is lit.
When a power interruption occurs during quick timer recording
The recording stops.
It will start
again when
the power
is supplied
within
about
60
minutes.
When the tape comes to an end before the preset turn-off time
The recording stops and the recorder will be automatically turned
off after about 30 seconds.
ADVANCED OPERATION
RECORDING LEVEL ADJUSTMENT
When
recording on Beta hi-fi system, the recording level of two
channels can be adjusted with the REC
LEVEL control and the
sound
volume
of each
channel
can
be adjusted with the REC
BALANCE control.
Usually,
such
as when
you
record
TV
program
sound,
proper
recording level is obtained by setting the REC LEVEL control at 5
(green position).
When you record a sound source which contains low level to high
level signals, for example,
sounds
from
microphones
or audio
equipment, manually adjusting the recording level may result in a
better recording.
If the recording
level setting is too high, the sound will distorted,
and if the setting is too low, a noisy recording will result. The
recording level should be set as high as possible while avoiding
distortion.
Adjust so that the meters
deflect to the red portion only
at the highest signal level.
A
YS
SD
Se
ee ee en
ema
-dB
oc
50
Kit)
20
15
ui]
ee
2
0
2
5
+dB
R
DE eee
ee
A
Adjust the control while
monitoring the input level
of the program source to
be recorded on the peak
level meters.
Start recording after adjusting the record level.
Advertisement
Table of Contents
