Kenwood TM-201A Instruction Manual page 16

(2) Programmable scan
16
144.5 &
144.0
Lower
limit
Upper limit
146.0
For Europe and
England
148.0
For others
Up scan Down scan
Procedure Operation indication |
Store lower and upper limit frequencies in
1 | Scan range setting | memory
channel 5 by operating the M, M5,
tuning control UP, DWN or MHz switch.
Hold the mic UP or DWN switch depressed for
2 | Scan start
more than one second. The scan starts. The dot
starts flashing.
3 | The scan will stop at busy station and resume In 6 seconds.
Scan resumes regardless of signal when
4 | Scan resume operating the tuning control or UP/DWN
switch.
Holding the UP/DWN switch depressed allows
rapid up or down scan.
Holding the MHz key depressed allows rapid
scan in 1 MHz steps.
During up scan, depressing the DWN key or
turning the tuning control one click to the left
6 | Scan direction reverses the direction.
During down scan, reversing the above pro-
Flashes
5 | Rapid scan
cedure reverses the direction. |
Holding the UP/DWN key depressed allows the |
scan to go beyond the upper or lower frequency
limit.
Example: During up scan from R to T, hold
the UP key depressed and allow the
scan to go beyond T. The scan goes
7 Other scan range
operation
from T to R.
| Depressing the A/B key or mic PTT switch o
8 | Scan release
releases the scan.
Lights
{ The flashing dot will stop.