Power Source Selection Menu - Miller 300739 Owner's Manual

6-12. Power Source Selection Menu

1
* * Power Source
Invision/XMT 35X MPa
Invision/XMT 450 MPa
Deltaweld 302
Deltaweld 452
Deltaweld 652
Dimension 302
Dimension NT 450
Dimension 452
Dimension 652
XMT 304
XMT 350
XMT 456
Invision 456
Invision 354
Optima
Custom
** For any power sources not listed, pick a matching voltage range or see
Section 6-6 to set Vmin and Vmax.
OM-273243 Page 20
Left Display Right Display
MPa 35X
MPa 450
DELT 302
DELT 452
DELT 652
DIM 302
DIM 450
DIM 452
DIM 652
XMT 304
XMT 350
XMT 456
456
INV
INV 354
OPT IMA
CUST PWR.S
2
Voltage Range
Vmin =10 Vmax =38
Vmin =10 Vmax =38
Vmin =10 Vmax =32
Vmin =10 Vmax =38
Vmin =10 Vmax =44
Vmin =10 Vmax =32
Vmin =10 Vmax =38
Vmin =10 Vmax =38
Vmin =10 Vmax =65
Vmin =10 Vmax =35
Vmin =10 Vmax =38
Vmin =10 Vmax =38
Vmin =10 Vmax =38
Vmin =10 Vmax =35
Vmin =10
Vmax =38
Vmin =10 Vmax =38
1 Left Display
2 Right Display
.
When the feeder is turned on,
the Power Source Selection
Menu allows the operator to se-
lect a default power source.
Selecting a default power
source, automatically sets the
correct Vmin and Vmax set-
tings for adjusting the output
voltage of the power source.
First Time Feeder Is Turned On
The feeder automatically goes into
the Power Source Selection Menu.
The feeder displays "MPA" on the
Left Display and "35X" on the Right
Display, meaning that a MPa 350
amp machine is the default power
source, and has a voltage range of
10V as Vmin and 38V as Vmax.
At power up, the operator has three
seconds to select a default power
source from the list shown on the
display. Operator may scroll
through the list of power sources by
using the Adjust control. After se-
lecting a power source the operator
has three seconds to change to a
different power source or begin
welding. When turning off the feed-
er, the default power source will be
retained.
Next Time Feeder Is Turned On
The feeder will display the last se-
lected default power source. The
operator has three seconds to se-
lect another power source, or press
the Program Button to exit the Pow-
er Source Selection Menu.