Fault
Brief whirring noise
after switching on the
appliance.
Loud noises during
the spin cycle.
Banging noises, rat-
tling in the drain
pump.
Slurping, rhythmical
suction noise.
Creasing.
The spin result is not
satisfactory. The laun-
dry is too wet/too
damp.
Cause and troubleshooting
Intelligent dosing system carries out a function test.
Not a fault – normal operating noise.
▶
Appliance is not correctly aligned.
→ "Aligning the appliance", Page 16
▶
The appliance feet are not fixed.
Secure the appliance feet.
▶
→ "Aligning the appliance", Page 16
Transit bolts have not been removed.
→ "Removing the transit bolts", Page 13.
▶
Foreign bodies have got into the drain pump.
→ "Cleaning the drain pump", Page 39.
▶
The drain pump is active, the detergent solution is
pumped out.
Not a fault – normal operating noise.
▶
The spin speed is too high.
The next time you run a wash cycle, set a lower
▶
spin speed.
The load is too large.
The next time you run a wash cycle, reduce the
▶
amount of laundry being loaded.
Unsuitable programme for the type of fabric.
Select the programmes that are suitable for the
▶
type of fabric.
A low spin speed is selected.
The next time you run a wash cycle, set a higher
▶
spin speed.
Start the Centrifugering (Spin) programme.
▶
is activated.
Select the programmes that are suitable for the
▶
type of fabric.
Drain pipe or water outlet hose is blocked.
Clean the drain pipe and the water outlet hose.
▶
Drain pipe or water drain hose is caught or jammed.
Ensure that the drain pipe and water drain hose are
▶
not kinked or trapped.
The unbalanced load detection system has interrupted
the spin cycle because the laundry is unevenly distrib-
uted.
Troubleshooting en
51