13.5 Adding detergent and
care product
For programmes in which intelligent
dosing is not possible or desirable,
you can add detergent manually.
Tip: In addition to intelligent dosing,
you can also add additional care
product for laundry, e.g. stain re-
mover, starch or oxygen bleach, to
the manual dosing compartment. Do
not add any additional detergent to
the manual dosing compartment to
avoid overdosage and/or foaming.
Note: Observe the information about
detergents and care products
→ Page 30.
Pull out the detergent drawer.
1.
Pour in detergent.
2.
→ "Detergent drawer", Page 17
If required, add the care product.
3.
Push in the detergent drawer.
4.
13.6 Starting the programme
Requirement: A programme is set.
→ "Setting a programme", Page 30
Press
.
▶
a The drum rotates and load detec-
tion takes place. This can take up
to 2 minutes, after which water
enters the drum.
a The display shows the programme
duration or the programme end
time.
a After the programme has ended,
the display shows: "End".
13.7 Soaking laundry
Note: No additional detergent is re-
quired for soaking. The appliance
uses the filled detergent for soaking
and washing.
Requirements
¡ The laundry is placed in the appli-
ance.
→ "Loading laundry", Page 30
¡ A programme has started.
→ "Starting the programme",
Page 31
Press
approx. 10 minutes after
1.
the programme start.
The programme pauses and the
laundry can soak.
Press
after the required soak-
2.
ing time.
13.8 Adding laundry
After the programme starts, you can
remove or add laundry depending on
the programme status.
Press
.
1.
The appliance pauses.
Note: If you want to add laundry,
follow the instructions on the dis-
play.
→ "Display", Page 22
Open the door.
2.
Add or remove laundry.
3.
Close the door.
4.
Press
.
5.
13.9 Cancelling the pro-
gramme
Press
.
1.
Open the door.
2.
The appliance door remains
locked for safety reasons if the
temperature and water levels are
high.
– If the temperature is high, start
the Sköljning (Rinse) pro-
gramme.
Basic operation en
31