Advanced Setup; Own Two Vcr's? Set Aux To Be Vcr2 - Universal Remote Unifier URC-100 Owner's Manual

Advanced Setup

After you've finished all your basic setup, you can
choose to make operation easier by customizing the
Unifier just the way you want, using the Advanced Setup
features described in this section.
Own Two VCR's?
Set Aux to be VCR2
Any device button can be setup for ANY type of
component (for example, you can make the AUX device
button operate a second VCR). To setup a device button
for a different type of component, use these steps:
Power on the A/V component you wish to setup, so that
1
you can test codes by sending power off commands.
Refer to the pre-programmed code tables on pages
2
25 - 46 and write down the code numbers listed
for your A/V component.
Press and hold both the SHIFT and ENT (Enter)
3
buttons for approximately three seconds. The top
of the display will blink "SET" for a moment.
SHIFT
Button
Note: You have 30 seconds for each step, otherwise the
Unifier will time out automatically.
U R C - 1 0 0
13
ENT
Button