Table of Contents
Advertisement
[ FM/AM/AIR/PSB reception |
SCAN TUNING
Use
scan
tuning
to automatically
scan
the stations
in the fre-
quency
range
of the
band
being
received.
Scanning
stops
automatically at each station.
The numbers in the illustration refer to the sequence of operations.
Depress the POWER switch (= ON).
Set the band selector to the desired band.
Depress the SQL control (= AUTO
).
Turn the VOL control slightly clockwise.
Press the SCAN
© or © key for at least 0.5 second to start
scanning, then release the key. The display changes continu-
ously and stops automatically when a station is received.
Pressing the @ key, the tuned frequency is increased.
Pressing the © key, the frequency is decreased.
OAawnhb
—
Press for at least
+
0.5 second
SCAN
vy 3
oan
-
=:
FM
Le
OLE LA
we
7
(SS RECEIVE
Repeat step 5 until the desired station is received.
6
Adjust the volume with the VOL control.
@ For AM reception, if necessary rotate the set horizontally for op-
timum reception.
@ To stop scanning, press the ® or © key momentarily.
After listening, set the POWER switch to m OFF.
If stations cannot be tuned in by scan tuning with the SQL control
set to = AUTO, press the SQL contro! again (ma MANUAL) and
adjust the control. (See "How to use the SQL control" on page 15.)
If scanning stops a little before a station, tune in the frequency
more precisely by manual tuning (See page 16.).
Note on scanning
Scanning is performed in the range of the band being received, at
the intervals shown
on page 13. When
the upper limit of the fre-
quency of that band is reached, the dial is scanned back to the
lower limit, and vice versa.
14
Advertisement
Table of Contents
