System And Operations Set Up; Setting Up The System; Macro And Punch Through Programming - Home Theater Master MX-1000 Operating Manual

6. Programming the Remote Control
3. Press the MUTE button to move the cursor to the DEVICE
BUTTON and keep the device button you wish to erase all the
learned commands down for five seconds until the LCD shows
ERASED. This will erase the function taught in the device button.
If you continue to press the device button for another five seconds,
it will erase all the functions in the device.
4. Once you complete the erasing and wish to exit from this mode,
press the MAIN button to go back to the main page of the learning
mode. Exit from the Main page by pressing the MAIN and PAGE
buttons simultaneously.
5. You will be in the setting mode once again. Move the cursor to
8. TO EXIT and press down the cursor or simply press the MAIN
button to exit to the main menu.
3) To erase all the learned commands in all twelve devices:
1. Go to the program setting mode by pressing both the MAIN and
PAGE buttons simultaneously for five seconds.
2. Move the cursor to 4. LEARNING with the joystick and then push
the joystick down to enter the learning mode.
3. Press both the POWER and STOP buttons simultaneously for five
seconds in the learning mode. The LCD will show ERASED after
it erased all the learned commands in the remote control.
4. Once you complete the erasing and wish to exit from this mode,
press both the MAIN and PAGE buttons simultaneously.
5. You will be in the setting mode once again. Move the cursor to
8. TO EXIT and press down the cursor or simply press the MAIN
button to exit to the main menu.
NOTE:
Preprogrammed code will be automatically restored when learned
function is crased.
15

7. System and Operations Set Up

Go to the program setting mode by pressing both the MAIN and
PAGE buttons simultaneously for five seconds. Move the cursor on
the LCD screen to 2. SYSTEM & OPTIONS with the joystick. Enter
this mode by pushing the joystick down and the following can be
programmed:
A. Setting Up the System.
The LCD screen will list the following choices.
Range
Buzzer Status: High,
Back Light On Time: 0 Ð 120 seconds
LCD on Time: 5 - 120 seconds
Warning of Low Battery: 10% - 50% level
Select the button you wish to change from the list first. Press the UP
or DOWN buttons on the LCD to set them up. Once you set them up,
press the SAVE button to store them.
You will be in the setting mode once again. To return to the main
menu, move the cursor to 8. TO EXIT and press the cursor down or
simply press the MAIN button to exit to main menu.
B. Macro and Punch Through Programming
The MACRO and PUNCH THROUGH can be also programmed in
this mode. Press the button you wish to program and follow
procedures shown below:
Default
Low, Off High
20 seconds
30 seconds
10 %
16