Learning Method - Home Theater Master MX-1000 Operating Manual

6. Programming the Remote Control
7. Point the remote control to the component and press the BRAND button.
8. Press the number button on LCD screen that corresponds with the
first alphabetical character of your brand name. ( Please press the
number button within 20 seconds of programming.)
Plcase note that pressing the number button will only show the first
alphabet of the brand in that alphabet group.
9. If the first code number assigned to the brand is the right one, it
will turn off the component. If it is not the right one or if it is not the
right brand name, press the Channel Up button. It will automatically
send out a POWER OFF command either from the next code
number from the same brand or the code from the next brand. Keep
the Channel Up button pressed until it turns off the component.
When the component turns off, save the code by pressing the SAVE
button on the LCD. ( Note: It is quite possible that the code number
that works with your component may have a different brand name
because of the way it was made by its manufacturer. )
11
6. Programming the Remote Control
NOTE: Confirm that it is the right code number for your
component by pressing other buttons such as POWER,
VOLUME, MUTE and CHANNEL, etc. If any of the buttons
do not operate as they should, please repeat from Step 5.
10. Continue to program other components by repeating from Step 5.
11. Once you have completed programming all the devices, exit from
the programming mode by pressing both the MAIN and PAGE
buttons simultaneously.
12. You will be in the setting mode. Move the cursor to 8. TO EXIT
and press the cursor down or simply press the MAIN button to exit
to the main menu.
B. Learning Method:
You can also teach any of the buttons in the remote control except
the MAIN and PAGE buttons with the following steps.
1. Go to the program setting mode by pressing both the MAIN and
PAGE buttons simultaneously for five seconds.
2. Move the cursor to 4. LEARNING with the joystick and then push
the joystick down to enter the learning mode.
3. If you wish to teach any of the functional buttons in the device,
keep the cursor to COMMON BUTTON and select the device that
you wish to enter. If you wish to teach the twelve device buttons
shown on the LCD, press the MUTE button to move the cursor to
the DEVICE BUTTON and select the device on the LCD that you
wish to teach into.
12