Rpm/Timing Sensor - Ducati SUPERBIKE 848 MY 2008 Manual

System components
parameters for defining the fuel flow rate and spark advance.
Notes
To check this component, use the DDS tester following the instructions given in the paragraph
diagnosis (Sect. D 5).
It is not possible to change the throttle position sensor as a single component. In the event of a fault
with this component, it will be necessary to replace the entire throttle body assembly (Sect. L 6,
Refitting the airbox and throttle
position sensor (TPS)).

Rpm/timing sensor

This sensor (1) is of the inductive type: it faces the timing gear and is capable of reading the 46 teeth
and the 2-tooth gap.
The signal coming from the pickup on the camshaft gear is used by the ECU to determine the engine
speed and as a timing reference point.
Notes
To check these components for faults, use the DDS tester and follow the instructions given in the
file:///C|/848/wsm/en/848_08_M_3_3_00.55.1.html (17 of 19) [11-6-2008 0:34:40]
body) and then reset the TPS (Sect. D 5,
WWW.PlanDeGraissage.ORG
Resetting the throttle
Guided