Cleaning And Care; Exterior; Door; Touch Control Panel - Beko WOSP30100SS User Manual

CLEANING AND CARE

11
Disconnect the power cord or leave the door open to
inactivate the oven during cleaning.

EXTERIOR

The outside surface is precoated metal and plastic. Clean
the outside with mild soap and water, then rinse and dry with
a soft cloth. Do not use any type of household or abrasive
cleaner.

DOOR

Wipe the window on both sides with a damp cloth to remove
any spills or spatters. Metal parts will be easier to maintain
if wiped frequently with a damp cloth. Avoid the use of spray
and other harsh cleaners as they may stain, streak or dull
the door surface.

TOUCH CONTROL PANEL

Care should be taken in cleaning the touch control panel.
If the control panel becomes soiled, open the oven door
before cleaning. Wipe the panel with a cloth dampened
slightly with water only. Dry with a soft cloth. Do not scrub
or use any sort of chemical cleaners. Close door and touch
the STOP/CLEAR pad.

INTERIOR - AFTER MICROWAVE COOKING

Cleaning is easy because little heat is generated to the
interior surfaces, so there is no baking and setting of spills
or spattering. To clean the interior surfaces, wipe with a soft
cloth and warm water. DO NOT USE ABRASIVE OR HARSH
CLEANERS OR SCOURING PADS. For heavier soil, use
baking soda or a mild soap, then rinse thoroughly with hot
water. NEVER SPRAY OVEN CLEANERS DIRECTLY
ONTO ANY PART OF THE OVEN.
INTERIOR - AFTER CONVECTION, SPEED
BAKE OR SPEED ROAST
Spatters may occur because of moisture and grease.
Wash immediately after use with hot, soapy water. Rinse
and polish dry. Harder to remove spatters may occur if
oven is not thoroughly cleaned or if there is long time/high
temperature cooking. If so, you may wish to purchase an
oven cleaner pad with liquid cleaner within it—not a soap
filled steel pad—for use on stainless or porcelain surfaces.
Follow manufacturer's directions carefully and be especially
cautious not to get any of the liquid cleaner in the perforations
on the wall or ceiling or any door surfaces. Rinse thoroughly
and polish dry.
After cleaning the interior thoroughly, residual grease may
be removed from the interior ducts and heater by simply
operating the oven on 450˚F (232˚C) for 20 minutes without
food. Ventilate the room if necessary.
Convection/Speed Microwave Oven User Manual

WAVEGUIDE COVER

The waveguide cover is made from mica so it requires special
care. Keep the waveguide cover clean to assure good oven
performance. Carefully wipe with a damp cloth any food
spatters from the surface of the cover immediately after they
occur. Built-up splashes may overheat and cause smoke
or possibly catch fire. Do not remove the waveguide cover.

ODOR REMOVAL

Occasionally, a cooking odor may remain in the oven. To
remove, combine 1 cup water, grated peel and juice of 1
lemon and several whole cloves in a 2-cup glass measuring
cup. Boil for several minutes using 100% power. Allow to set
in oven until cool. Wipe interior with a soft cloth.

TURNTABLE/TURNTABLE SUPPORT

The turntable, turntable support and racks can be removed
for easy cleaning. Wash them in mild, sudsy water. For
stubborn stains, use a mild cleanser and a non-abrasive
scouring sponge. The turntable, turntable support and racks
are also dishwasher-safe. Use top rack of dishwasher for
turntable support.
Foods with high acidity, such as tomatoes or lemons, will
cause the porcelain enamel turntable to discolor. Do not cook
highly acidic foods directly on the turntable. If spills occur,
wipe up immediately.
The turntable motor shaft is not sealed, so excess water or
spills should not be allowed to stand in this area.
23 / 51 EN