Troubleshooting; Resetting The Handset; Resetting The Base - Uniden WIN1200 Series Owner's Manual

Troubleshooting

Resetting the Handset

You may need to reset your handset when you want to change the digital security code or when you are instructed to
by one of Uniden's call center representatives.
1. Press and hold
END
2. Use the joystick to highlight DEREGISTER HS and press the center of the joystick or the Select soft key.
3. The phone will ask you to confirm the deregistration. Select YES. The handset will clear its registration
information from the base, and then delete the link to the base from its own memory.
4. When the base information is deleted, the handset displays MUST PLACE HANDSET IN BASE TO
REGISTER. MODELS MAY VARY, REFER TO OWNER'S MANUAL FOR HELP.
5. Place the handset in the base to reregister the handset.
If the handset cannot contact the base, it will display UNAVAILABLE. Make sure the handset is in range of the base
and the base is connected to power.

Resetting the Base

You may need to reset your base if your handset has been damaged and you want to replace it or when you are
instructed to by one of Uniden's call center representatives.
1. Disconnect the AC adapter.
2. Press and hold
FIND HS
begins to blink.
3. Place the handset in the base to reregister the handset.
and # for at least 5 seconds, until the system reset menu displays.
while you reconnect the AC adaptor. Continue holding
53
until the charge light
FIND HS