Table of Contents
Advertisement
The digital security code is an identification code used to connect the handset and the
base unit. Normally, setting the code is not necessary. In the rare situation that you
suspect another cordless telephone is using the same security code, you can change the
code. To change the digital security code, de-register the code, then register a different
code.
De-register the Digital Security Code
1) Remove the handset from the base. In the standby mode, press and hold xfer/del and
end for 10 seconds. You will hear a confirmation tone. "
2) Press + to select "
", then select/ch. You will hear a confirmation tone, and
"
• If you have not pressed any key for 30 seconds while in the de-registering operation, the
phone returns to the standby mode.
• While in the de-registering operation, if you receive an incoming call, page, or transferring call,
or charge the handset, or press talk/flash, spkr or end, the operation is canceled.
" appears.
" appears.
A D D I T I O N A L I N F O R M A T I O N
You will need to re-
register the additional
handset each time you
change the digital
security code of the
original unit.
[ 43 ]
Advertisement
Table of Contents
