Sony TRINITRON PVM-8041Q Service Manual page 8

PVM-8041Q/8044Q
Rear
EH LINE A connectors
To monitor the signal fed through these connectors,
keep the LINE/RGB selector and the A/B, RGB/Y R-Y B-
Y selector on the front panel released (LINE and A).
U33
The Y/C IN connector has a priority over the VIDEO IN
connector.
When a plug is connected to the Y/C IN connector, the
VIDEO IN connector is automatically disconnected.
EH LINE B connectors
To monitor the signal fed through these connectors,
keep the LINE/RGB selector released (LINE) and
depress the A/B, RGB/Y R-Y B-Y selector (B) on the
front panel.
VIDEO IN (BNC): Connect to the video output of a video
camera, VCR or other video equipment.
VIDEO OUT (BNC): Loop-through output of the VIDEO
IN connector. Connect to the video input of a VCR or
another monitor.
AUDIO IN (phono jack): Connect to the audio output of
a VCR or a microphone (through a suitable
microphone amplifier).
AUDIO OUT (phono jack): Loop-through output of the
AUDIO IN connector. Connect to the audio input of a
VCR or another monitor.
E3 TALLY/REMOTE connector (8-pin mini DIN)
Connect to the tally output of a control console,
special-effect generator, etc. The tally lamp on the front
panel will be turned on and off by the connected
equipment. This connector can be used for connecting a
remote controller. For the pin assignment of this
connector, see "Specifications" on page 2.
HH EXT SYNC (external sync) connectors
IN (BNC): When this monitor operates on an external
sync signal, connect the reference signal from a sync
generator to this connector. In this case, depress the
SYNC INT/EXT selector (EXT) on the front panel.
OUT (BNC): Loop-through output of the EXT SYNC IN
connector. Connect to the external sync input of video
equipment to be synchronized with this monitor.
|g] V HOLD (vertical hold) control
Turn to stabilize the picture if it rolls vertically.
[HI DC 12V IN jack (XLR, 4 pin)
Connect the Sony AC-500 AC power adaptor (not
supplied).