10
Basic operations of remote (See page 8)
Function of the KRC-603C/ 503, Optional for the KRC-403
Do not set the remote on hot places such as above the dash-
board.
Replacing the Lithium Battery:
Use one lithium battery (CR2025).
Remove the case following the instructions as illustrated.
Se
age
|
@
To open
@ Keep on slide
@)
2) Pull out.
Store unused lithium batteries out of the reach of children.
Contact a doctor immediately if the battery is accidentally swal-
lowed.
All Modes
e VOL. buttons
Press the "A button to turn the volume up.
Press the \
button to turn the volume down.
e TUNER button
Selects the tuner mode. Pressing this button again selects the
standby mode.
¢ TAPE button
Selects the tape mode.
*¢ CDeMD CH button
Selects the disc changer mode.
¢ Number buttons
Press buttons #1-6 to recall preset stations.
During direct access tuning, use these buttons to input the fre-
quency of the station.
¢ TUNE buttons
Press the TUNE —
button to decrease the frequency.
Press the TUNE + button to increase the frequency.
e AM/FM button
Press the AM button to select the AM band.
Press the FM button to select and switch between FM1, FM2,
and FM3 bands.
¢ DIRECT button
Selects the direct access tuning mode, used to input frequen-
cies directly. Press this button again to cancel the mode while it
iS Operating.
Tape Mode
¢ T.ADV (q<4/m1)
buttons
Press the k@ button to start play again at the beginning of the
current track
Press the ml
button to start play at the beginning of the next
trate b
¢ REW button
Rewinds the tape
e FF button
Fast forwards the tape
¢ PROG button
Plays that rewetue side of the tape
VWhen pressed during fast for
Wald
af utes.
of thes tutto
stops
the tape and stats
playing It