Using The Answering System; Answering System Options (Ans. Setup); Personalizing The Greeting - Uniden D3280-2 User Manual


When you select
Access number if you have not yet set one up (see p. 9). If you have
already set one up, your phone will dial it.
After you listen to your messages, the message icon turns off. If it doesn't, you can
reset it: With the phone in standby, open the menu and select
VMWI Reset, then select Yes.

USING THE ANSWERING SYSTEM


The answering system works with land-line calls only.
Answering System Options
You can set or change the answering system options from any handset. Just open the
menu and select Ans.
Select this option...
Security Code
Ring Time
Record Time
Message Alert
Ans. Language
Call Screen
Ans. On/Off
Record Greeting
Greeting Options

Personalizing the Greeting

Your personal outgoing message or greeting can be from 2 to 30 seconds long. If you
don't record a greeting, the system uses a pre-recorded greeting: Hello, no one is
available to take your call. Please leave a message after the tone.
1 - English
Voice Mail, you will be prompted to enter a Voice Mail
(Ans.
Setup)
Setup.
To...
Enter a 2-digit PIN so you can access your answering
system from any touch-tone phone (see p. 21).
Set the number of rings (2, 4, or 6) before the system
answers. Toll Saver
if you have new messages or after 4 rings if you don't.
Set the amount of time
leave a message. Choose
the system to let callers to leave a message.
Have the system beep every 15 seconds when you have
a new message. The alert stops after you listen to all your
new messages or if you press any key on the base.
Change the language of the system's voice prompts.
Turn on the call screen feature so you can hear callers as
they leave messages on the base speaker (see p. 20).
Turn your answering system on or off.
You can also press
Record an outgoing message or greeting (see below).
Switch greetings or delete your greeting (see below).
Global
makes the system answer after 2 rings
(1 or 4 minutes) callers have to
Announce Only
answeR on/oFF on the base.
Setup; select
if you don't want