Programming With Search - Uniden SC150B User Manual

7. Press
display will blink twice to confirm the programming.
8. If that frequency is already stored in another
channel, you will hear a "beep", and the other
channel number will appear on the display. If you
want to store the frequency in the selected channel
(18) as well, press
blink twice to confirm the programming. Or, you can
press
currently selected channel.
Note: Any frequency already stored in any channel will
automatically be replaced by the new one.
9. If you try to enter a frequency that is outside one of
the 12 Bands, you will hear a "beep", and the word
"Error" appears on the display.
Press
10. To program another channel, repeat the above
procedures.
Deleting a Stored Frequency
To delete a frequency from a channel:
1. Display the channel and frequency that is to be
deleted.
2. Press
3. Press
display shows 000.000.
Note: That channel will be skipped during scanning.
B. Programming With SEARCH
The Search feature enables you to rapidly search for active
frequencies within the specified band limits. When an
interesting frequency is found, you can store it into a
channel using the procedure below. For more information
about SEARCH Mode, see the later section titled
"Searching".
1. Press
E
to store the entry. The frequency on the
.
twice and enter another frequency for the
.
twice and re-enter the correct frequency.
0
on the numeric keypad.
E
. The current channel is erased, and the
N
to enter the SEARCH Mode.
E
again. The frequency will
15