Changing The Scsi Id Number - UMAX Technologies Astra 1200S Operation Manual

Changing the SCSI ID Number

If you have other devices connected to your SCSI port, you need to check and see what SCSI ID's are
already used. The scanner is preset at the factory to SCSI ID 5.
If, after checking other devices in the SCSI chain, you find that SCSI ID 5 is unused, you do not need to
change the ID on the scanner and you can go ahead with the installation.
If, however, after checking other devices in the SCSI chain, you find that another device uses SCSI ID 5,
you must change the SCSI ID on your scanner.
To change the SCSI ID, do the following:
1. Make sure the scanner is turned off.
2. Gently turn the switch until an unused number appears in the switch's notch.
Note: Do not use SCSI ID 8 and 9 on your scanner. They are for factory use only.
8