US Robotics USR5432 Quick Installation Manual page 7

B. Connect the supplied Ethernet cable to the LAN port of the Wireless MAXg Bridge and to a
LAN port on a networking device, such as a router.
existing router
C. Connect the power adapter to the Wireless MAXg Bridge and to a standard wall power out-
let.
existing router
Note to UK Users: Attach the correct power plug to the power adapter.
Step Two: Locate the Bridge in your network
Note: It is recommended that the Wireless MAXg Bridge is always configured via an Ether-
net connection. This will ensure the configuration changes are made without modifying
the properties of any wireless cards in your network.
Windows Users
A. Insert your U.S. Robotics Installation CD-ROM into the CD-ROM drive of a computer con-
nected to the existing router. The Installation CD User Interface will appear on your screen.
If prompted, select your preferred language. Follow the on-screen instructions to install and
launch the Detection Utility.
Note: If your CD-ROM does not automatically launch, click Windows Start, Run, type
D:\setup (or the appropriate letter of your CD-ROM drive), and click OK.
B. When the Detection Utility opens, follow the on-screen instructions.
C. After the devices on your network are detected, determine which is your Wireless MAXg
Bridge by matching the LAN MAC addresses. The LAN MAC address of the Wireless MAXg
Bridge is located on the label on the bottom of the Wireless MAXg Bridge. If you do not see
the LAN MAC address for your Wireless MAXg Bridge, make sure it is connected properly
and click Detect to scan your network again. Select the LAN MAC address for your Bridge
and click Next.
D. Click Finish to exit the Detection Utility and to open the Web User Interface in a new browser
window.
B
Wireless MAXg Bridge
Wireless MAXg Bridge
C
4