Recalling Stored Measurement Values - Panasonic EW3152 Operating Instructions Manual

RECALLING STORED MEASUREMENT VALUES
20
Press tre mR (memory/recall) button for the
person whose data you want to recall.
The average of all measured values in memory will be
shown.
* CIJ mark will be shown at the bottom of the display.
e For example, if 90 measured values are stored, the
average of the 90 measurements will be shown. (If
only 1 measurement is stored, the mark will not
be shown.)
e The blood pressure indicator lamps will light (for
approximately 6 seconds).
Press the WR (memory/recall) button again.
Each time you press the M/R (memory/recall)
button, the previously stored measurement values
will be SHOWN in order, starting with the newest
data.
The blood pressure indicator lamps will light (for
approximately 6 seconds).
If no measurement values are stored, no value will be
shown.
Press the M/R (memory/recall) button lightly for only a
short time. If you hold the button pressed for
approximately 3 seconds or longer, all data in memory
will be erased, so please be careful.
To cancel measurement value recall,
press the On/Off Start button.
e If you forget to switch it off, the blood pressure
monitor will switch off automatically after
approximately 30 seconds.