Recalling Stored Data; Deleting Data - Panasonic EW3002 Operating Instructions Manual

Easily Check Your Blood Pressure Readings
Against the World Health Organization (WHO)
Guidelines
Blood Pressure Categories
SYSTOLIC BLOOD
CATEGORY
PRESSURE (SBP)
Normal
Normal High
Low Hypertensive
Moderate Hypertensive
Severe Hypertensive
If your systolic pressure falls in one category but your diastolic pressure
in another, your level is classified in the higher of the two categories.
IMPORTANT:
• WHO does not define a low blood pressure area. For reference, systolic
pressure readings of less than 90 mmH are considered to indicate low
blood pressure regardless of the diastolic pressure.
• Do not be alarmed by temporarily high or low readings because fluctuations
in a person's blood pressure are not uncommon. If possible, measure and
record your blood pressure at the same time every day, and consult your
physician if you have questions or concerns.
• If abnormal variations in blood pressure are observed in measurement,
please consult your physician.
13
DIASTOLIC BLOOD
PRESSURE (DBP)
< 130 < 85
130-139 85-89
140-159 90-99
160-179 100-109
> 180 > 110

Recalling Stored Data

1. Press the Recall button (Fig. 13). The
the display, and then the average value of all the stored data will be
displayed (Fig. 14).
• For example, if seven data (measurements) are stored in the memory,
the average value of these seven data will be displayed. If there is no
data in the memory or if there is only one data in the memory, the
will not be displayed.
2. By pressing the Recall button repeatedly (Fig. 15), you can browse through
all the stored data sequentially from the newest data to the oldest (Fig. 16).
• If no data is in the memory, nothing will be displayed.
Note:
Press the Recall button lightly and briefly. If the Recall button is pressed
continuously for more than about 2 seconds, all stored data will be deleted.
3. Press the Start (On/Off) button to finish.
• If the data is recalled while the blood pressure monitor is turned off, the
monitor will turn off automatically after about 30 seconds.
Fig. 13 Fig. 14
SYS.
SYS.
mmH
mmH
DIA.
DIA.
mmH
mmH
P/min. P/min.
On/Off On/Off
R R
Start Start

Deleting Data

1. Press the Recall button.
2. Press the Recall button again until the recalled data disappears from the
display (about 2 seconds).
• ALL data will be deleted. Individual stored data cannot be deleted
independently.
A will appear in the lower part of
Fig. 15 Fig. 16
SYS.
SYS.
mmH
mmH
DIA.
DIA.
mmH
mmH
P/min.
P/min.
R On/Off
R On/Off
Start
Start
A
14