After Unpacking - Kenwood TS-930S Instruction Manual

AFTER UNPACKING
It is advisabte to save all original packing cartons (inner and
outer] to protect your valuable transceiver from damage
should you wish to transport it for remote operation or ship
it for after-sales service.
The following explicit definitions apply in this manual. Be
sure to read these definitions:
NOTE: if distegarded, inconvenience only — no
damage or personal injury.
NOTE: This manual covers the TS-930S with the
AT-930 Automatic antenna tuner installed.
If your transceiver dees not contain the
AT-930, please disregard any mention of
Automatic antenna tuner operation.
CAUTION: ———___--
Read Operating Manual Section § before placing transmit-
SECTION 3. {INSTALLATION
3.1. Unpacking
3.2 Operating precautions
3.3 Operating Location
3.4 Cabling
3.5 Microphone
3.6 Key
3.7 External Speaker and Headphones
3.8 Ground
3.9. Antenna
SECTION
4. CONTROLS AND THEIR FUNCTIONS
10
4.1 Front Panel
4.2 Rear Panel
SECTION 5. OPERATION
5.1 Reception (I)
(1) Basic Procedures for Receive Operation
{2), WWV Reception
5.2 Reception (1D
(i) RE ATT Switch
(2) RF Gain Controt
(3) AGC (Automatic Gain Control)
{4} RIT
(5) SSB SLOPE TUNE Control
(6) CW VBT Control
{7} Notch Control
{8} AF TUNE Circuit
(9) Noise Blanker (NB}
14
5.5 BAND Switch
5.6 Two VFO Operation
5.7 MEMORY CH Operation
5.8 TF SET Operation
5.9 COOLING FAN Operation
5.10 SHORT WAVE RECEPTION
SECTION 6. OPTIONAL ACCESSORIES _..........
22
6.1 PERIPHERAL Devices and Options
6.2 Installation of Accessories
6.3 Optional Fitter Installation
6.4 AT-930 Installation
6.5 Remote Control Wiring
8.1 Preparation
8.2 Adjustments
8.3. Maintenance
8.4 Transmitting WARC bands