U-Line Echelon CO2075FF Installation Manual page 9

™
13/32"
0.177" Dia. (#16 Drill)
x 11/16" Deep
3/8"
13/16"
Top View
1/8"
13/32"
13/16"
1-17/32"
7/16"
13/16"
5/16" Dia.
x 1/2" Deep
Back View
Figure 16
Route notch in top corner of overlay panel as shown
(see Top and Side Views). Top of notch is entire depth
of panel, front to back.
Width: 13/16"
Depth: 1/8"
Route notch in backside of top corner of overlay panel
(see Back and Side Views).
Width: 13/16"
Depth: 1/8"
Height: 1-17/32" from top edge of panel (less 1/8" for
depth of notch on top of panel)
Radius of corner notch: 1/8" (see Back View)
3. Drill holes for pivot plate mounts (see Figure 16, Back
View).
5/16" diameter x 1/2" deep, from the routed surface
CAUTION
Be careful not to drill too deep! Drilling holes too deep
may destroy your door panel.
02/2005
CO2075FF — Ice Maker/Refrigerator
13/32"
3/8"
Door Bottom:
5/16" Dia. x 1/4" Deep
Chamfer 1/32" x 45°
Bottom View
1/8"
1/8"
1/32" R
1/8" R
3/4"
Side View
4. Drill hole for upper door hinge (top of panel) (see
Figure 16, Top View).
0.177" diameter
(#16 drill) x 11/16" deep
5. Drill hole for lower door hinge (see Figure 16, Bottom
View).
5/16" diameter x 1/4" deep
It is important to ensure that all drilled holes are drilled to
the correct depth in order to avoid splits in the wood
when hardware is installed.
Installation Instructions
Removing Existing Door
1. Remove the door shelves by first pulling shelves
up at a 45° angle then straight out (see Figure 37
on Page 15).
2. Remove top hinge screw pin (7/64" hex key or Phillips
screwdriver, depending on your unit's construction).
Remove the door by tilting forward and lifting off the
bottom hinge pin.
3. Pull door gasket out of the groove (top edge of door
only). Start in the middle and pull outward, moving
toward the edge (see Figure 17). This may take some
force.
Figure 17
4. Remove the three screws located on the back of the
handle (see Figure 18).
9
CAUTION
New Handle
Old Handle
Figure 18
www.U-LineService.com