Table of Contents
Advertisement
Welcome message appears.
4. If you are prompted for a password, press the arrow keys to enter a 6-digit password. See
Utilizing the password function on page
5. Switch all of the connected equipment on.
6. The projector will search for input signals. The current input signal being scanned appears.
If the projector does not detect a valid signal, the message "No Signal" will appear until an
input signal is found.
You can also press
page
30.
• Please use the original accessories (e.g. power cord) to avoid possible dangers such as electric shock
and fire.
• If the projector is still hot from previous activity, it will run the cooling fan for approximately 90 seconds
before energizing the light source.
• The Setup Wizard screenshots are for reference only and may differ from the actual design.
• If the frequency/resolution of the input signal exceeds the projector's operating range, you will see the
message "Out of Range" displayed on the background screen. Please change to an input signal which is
compatible with the projector's resolution or set the input signal to a lower setting. See
page
58.
• If no signal is detected for 3 minutes, the projector automatically enters saving mode.
24 Operation
28.
to select your desired input signal. See
Switching input signal on
Timing chart on
Advertisement
Table of Contents
