Opening The Door; Loading Laundry; Starting The Programme; Adding Laundry - Bosch WNC254ARGB User Manual And Installation Instructions

en Basic operation
Press and hold Favourite for ap-
▶
prox. 3 seconds.
Press Favourite to call up the
saved programme.
Note: To overwrite the saved pro-
gramme, repeat the steps above.
13.5 Opening the door
Press on the edge of the door.
1.
Open the door.
2.
13.6 Loading laundry
Note: To prevent creasing, note the
maximum load for the programmes.
→ "Programmes", Page 28
Requirements
¡ The laundry is prepared and sor-
ted.
→ "Laundry", Page 32
¡ The drum is empty.
34
Open the door.
1.
→ "Opening the door", Page 34
Place the laundry in the drum.
2.
Close the door.
3.
Ensure that there is no laundry
trapped in the door.
13.7 Starting the programme
Note: If the intelligent dosing system
is activated, make sure that the dis-
pensers have been filled → Page 36
and the basic dosage has been set
→ Page 37.
Requirement: A programme is set.
→ "Setting a programme", Page 33
Press .
▶
a The drum rotates and load detec-
tion takes place. This can take up
to 2 minutes, after which water
enters the drum.
a The display shows the programme
duration or the programme end
time.
a After the programme has ended,
the display shows: "End".
13.8 Adding laundry
After the programme starts, you can
remove or add laundry depending on
the programme status.
Press .
1.
During the washing cycle, the ap-
pliance pauses.
During the drying cycle, the appli-
ance checks whether it is possible
to add laundry.
Note: If you want to add laundry,
follow the instructions on the dis-
play.
→ "Display", Page 24
Open the door.
2.
→ "Opening the door", Page 34
Add or remove laundry.
3.
Close the door.
4.