Rosemount Wireless Wt210 Corrosion Transmitter Installation - Emerson Rosemount Wireless WT210 Quick Start Manual

October 2023
4 Rosemount Wireless WT210 Corrosion
Transmitter Installation
Once you have installed the Universal mount onto the pipe,
you can then proceed to install the Rosemount Wireless WT210
Corrosion Transmitter Installation. This installation procedure for the
transmitter can be found in Rosemount WT210 Wireless Corrosion
Transmitter
Note
The lanyard of the sensor is to be secured to one of the lanyard holes
on the base of the universal mount.
4.1 Removal and re-installation of Universal Mount for
Rosemount Wireless WT210 Corrosion Transmitter
To remove the corrosion transmitter and mounting system from your
asset, follow the instructions detailed below.
WARNING
Two people are required for this operation
Personal protective equipment (PPE) of gloves and safety glasses or
full-face visor are recommended.
DO NOT cut the strap while it is under tension because this action
can result in injury or damage.
Cut strap may have sharp edges.
1. Remove the Rosemount Wireless WT210 Corrosion
Transmitter from the clamp, by untightening the nuts on the
studs which are holding the transmitter in the mount.
2. Attach the sensor installation handle to the studs in the
mount.
3. Using the 13 mm deep socket and torque wrench loosen the
tensioning bolts on the Universal Mount so that tension is
removed from the strap.
Quick Start Guide
Quick Start Guide.
Quick Start Guide
17