Table of Contents
Advertisement
I With a DSS Receiver
[
You can:
1)
Record and view any channel
including
scrambled
channels;
channel
selection
must be made at the DSS Receiver.
IN FROM
CABLE or Antenna
DSS
2)
Program one channel for unattended
recording.
NOTE:
The DSS receiver must be tumed off to view
programs from a cable box or antenna. See the
DSS manual for details.
IN FROM
Satellite Dish
IN FROM ANT.
OUTTO TV
"*DSS_) is a registered trademark of DIRECTV, INC., a unit of GM Hughed Electronics.
VHFAJHF
I Audio/Video
Connections
[
TV
If your TV has AUDIO IN and VIDEO IN terminals, you can connect your
VCR to them to receive a higher quality picture and sound. If your TV is not
stereo, you can connect a stereo amplifier to the VCR to enjoy stereo sound.
VCR
FROM ANT
VIDEO IN
1
Connect the VIDEO OUT terminal on the
VCR to the VIDEO IN terminal of your TV.
2
Connect the =L" and =R_AUDIO OUT terminals on the VCR to the =L" and =R" AUDIO IN terminals of your TV.
3
Set the VIDEO/TV selector of your TV (Monitor/Receiver) to =VIDEO."
NOTE:
To use yourTV as a VCR monitor,setthe VIDEO/TV selectoron the TV (Monitor/Receiver) t o =VIDEO."
Use the L AudioIn jackfor propersoundreproduction w henconnecting to a monauralTV.
I Stereo Amplifier
Connections
I
Whenyou connectyourVCR to a Stereo
Component System,you can viewthe
picturefrom the VCR whileenjoying
stereofrom your audiosystem.
Connect the =L" and =R"AUDIO OUT
terminalson the VCR to the =L"and "R"
AUDIO IN terminalsof your stereo.
StereoAmplifier
VCR
Note to CABLE system installer:.
This reminder is provided to call the CABLE system installer's attention to Article 820-40 of the NEC in USA (and to the
Canacl[an Electrical Code in Canada) that provides guidelines for proper grounding and, in particular, specifias that the
cable ground shall be connected to the grounding system of the building, as close to the point of cable entry as practical.
9
Advertisement
Table of Contents
