Table of Contents
Advertisement
Co"
YourTa
es(Dubbing)
Connections
you'll need to make. (Choose
front or rear connection.)
• When connecting to a normal VCR, use the L Audio In jack for proper sound reproduction.
Playing (Source) VCR
Recording (Editing) VCR
TV for Monitoring
Out
1
Insert a pre-recorded
tape into the Playing
(Source) VCR.
2
Insert a blank tape with
record tab into the
Recording (Editing) VCR.
s
3
Select "LINE" Input mode on the
Recording (Editing) VCR. (See "Selecting
the Input Mode" at right.)
4
Press PLAY on the Playing VCR.
Press PAUSE at the desired starting point.
5 Press REC on the Recording VCR, and then
press PAUSE immediately thereafter.
6
Press PAUSE on both VCRs at the same
_ime, to be ain coDYina.
To Monitor
Dubbing
on Your TV
1
Tum your TV on and tune to the Recording
VCR channel (CH3 or CH4).
2 Set the VCR/'W Selectoron
the Recording
VCR to =VCR."
Selecting
the Input Mode
Press INPUT.
The display will change in the order below.
_.
Channel
Number------.,-_ LINEI--_
LIN_._"
or
Press CH ,_.
The display will change in the order below.
.--.._ 1 -- 2-- 3
(CABLE)(TV))
".LINE2.4-LINEI<-- 125 or 069_m
-_
• UNEI: For rear audio/videoconnection.
• LINE2: Forfrontaudio/videoconnection.
To Edit Out Unwanted Parts
Press PAUSE on the recording VCR while copying is
in progress. Press PAUSE again to resume copying.
7
Press STOP on both VCRs to StODcoDyin9.
34
• When LINE isselected,=LI" or "L2"is displayedin the
MultiFunctionDisplayforabout 4 seconds.
I Caution."
Unauthorized exchanging and/or copying of copyrighted |
recordings may be copyright infringement.
J
Advertisement
Table of Contents
