Sony KP-48V80 Operating Instructions Manual page 16

ms
Connecting a DVD Player (Upper
illustration)
Using an AUDIO and S VIDEO cables,
connect AUDIO and S VIDEO IN on the
projection TV to AUDIO and S$ VIDEO OUT
on the DVD Player (White-AUDIO Left, Red-
AUDIO Right).
Connecting a DVD Player with
component video output
connectors (Lower illustration)
1
Using an AUDIO cable, connect AUDIO of
LINE OUT on the DVD Player to AUDIO of
VIDEO 4 or 5 IN on the projection TV
(White-AUDIO Left, Red-AUDIO Right).
Using three yellow VIDEO cables, connect
Y, Ps, and Prof COMPONENT VIDEO
OUT on the DVD Player to Y, Px, and Pr of
VIDEO 4 or 5 IN on the projection TV.
Notes:
12
Since the high quality pictures ona DVD
disc contain a lot of information, picture
noise may appear. In this case, adjust "Noise
Reduction" in the Video menu. (see "Noise
Reduction" on page 30)
Some DVD Player terminals may be labeled
differently. If so, connect as follows:
Connect Y (green) to Y.
Connect Ps (blue) to Cs, Cb or B-Y.
Connect Pr (red) to Cr, Cr or R-Y.
Installing and Connecting the Projection TV (continued)
Disconnect all power sources before making any connections.
S VIDEO (Rear of projection TV)
Audio/S video
outputs
AUDIO-L
RK-74A (not supplied)
Connect the DVD Player
directly to the projection TV.
YC-15V/30V (not supplied) Connecting the DVD Player
through other video
equipment will cause
unwanted picture noise.
VMC-10HG (not supplied)
(Rear of
projection
TV)
RR a RE OEE aR Be 9a oN onan cpa