Sony KP-48V80 Operating Instructions Manual page 12

MS ix
Connecting a satellite receiver
(SAT) and a VCR
1 Connect the cable from the satellite
antenna to the satellite receiver.
2 Attach the coaxial cable from the
incoming cable connection or antenna to
VHF/UHF IN on the VCR.
3 Using a coaxial cable, connect VHF/UHF
OUT on the VCR to VHF/UHF on the
projection TV.
4 Using AUDIO and S VIDEO* cables,
connect AUDIO and S VIDEO OUT on the
satellite receiver to AUDIO and S VIDEO
IN on the VCR.
5 Using AUDIO and S VIDEO* cables,
connect AUDIO and S$ VIDEO OUT on the
VCR to AUDIO and S$ VIDEO IN on the
projection TV (White-AUDIO Left, Red-
AUDIO Right).
*If your VCR is not equipped with S VIDEO, use a
VIDEO cable (yellow) instead of the S VIDEO
cable.
Note:
¢ To view input from the satellite receiver or
VCR, select the video input which your
satellite receiver or VCR is connected to
by pressing TV/VIDEO on the remote
control.
Installing and Connecting the Projection TV (continued)
Disconnect all power sources before making any connections.
(Rear of projection TV)
3 Coaxial cable
SAT
~~
AOI A AUDI WED pat ow
Satellite YC-15V/
antenna 4 4 30V
cable (not
S$ VIDEO VMC-810S/820S 'aisle!
(not supplied)
VCR =990 4 "9
49
VMC-810S/820S (not supplied) yo
ti
Antenna
YC-15V/30V (not supplied)
PON OG OLE LA ASLAN ANA LEGACY