Table of Contents
Advertisement
Store Test Results (1537/1537-II only)
When the insulation test is done, the Tester shows a prompt to save the results.
The Tester memory stores the results of up to 99 insulation tests.
To store the results of an insulation test:
1. Push
to save the measurement results. The Tester assigns and displays a
sequential tag number to identify the measurement.
2. If the tag number is acceptable, push
convention is required, create a custom 4-character tag:
a. Notice that the active character is blinking on the display. This is the first of
the four characters available for tagging the test results. Repeatedly push
to cycle through the character positions.
b. At each character position use
c. Push
View Test Results Stored in Memory (1537/1537-II only)
Parameters not appropriate for a test are shown as NA or UNSPEC.
The Tester can store 99 sets of test data, including:
•
Tags
•
Ramp on or off
•
Insulation Resistance
•
Timer reading at termination of test (Timer)
•
Test Voltage Selected (TV)
•
Actual Test voltage (V)
•
Capacitance (C)
•
Polarization Index (PI)
•
Dielectric absorption ratio (DAR)
•
Dielectric discharge (DD)
•
T1, T2, T3 (time, voltage, current and resistance.)
•
Test current (I)
•
Reason for ending the test
•
Limit – off or timer setting (1 to 99 minutes) (T. Limit)
to store the results.
to store the data. If a different tag
or
to assign a character (0-9, A-Z, a-z).
Note
Insulation Tester
Insulation Test
19
Advertisement
Table of Contents
