Removing Transportation Safety Bolts; Connecting To Water Supply - Beko GWP810616MW User Manual

Tilt the machine back slightly. Rest the tabs
of Cover A against the lower panel. Com-
plete the assembly by rotating the cover.
• Cover B and the Cap are optional. If avail-
able, attach cover B and the Cap.
Cover B
Rest the tabs of Cover B against the lower
panel. Complete the assembly by rotating
the cover.
Cap
Insert the cap by pushing it with your finger.
4.3 Removing Transportation
Safety Bolts
a. Loosen all transportation safety bolts with
an appropriate wrench until they turn
freely.
b. Bend the inner part by pressing it at the
grip areas and pull the part out.
c. Attach the plastic covers supplied in the
User Manual bag into the holes on the
rear panel.
NOTICE
Remove the transportation safety
bolts before operating the product.
Otherwise, the product will get dam-
aged.
NOTICE
Keep the transportation safety bolts
in a safe place to reuse when the
product needs to be moved again in
the future.
Install the transportation safety bolts
in reverse order of the disassembly
procedure.
Never move the product without the
transportation safety bolts properly
fixed in place.

4.4 Connecting to Water Supply

NOTICE
Models with a single water inlet shall
not be connected to the hot water
tap. In such a case the laundry will
get damaged or the product will
switch to protection mode and will
not operate.
Do not use old or used water inlet
hoses on a new product. It may
cause water leakage from your ma-
chine and stain your laundry.
a. Tighten all hose nuts by hand. Never use
a tool when tightening the nuts.
b. Open the taps completely after making
the hose connection to check for water
leaks at the connection points. If any leak
occurs, turn off the tap and remove the
nut. Check the gasket and tighten the nut
carefully again. In order to prevent the
water leaks and resultant damages, keep
the taps closed when you do not use the
product.
EN / 13