Table of Contents
Advertisement
10
|
Configuration
10 Configuration
10.1 To set a different address
Installer reference guide
44
In case 2 indoor units are installed in 1 room, different addresses for 2 user
interfaces can be set.
1 Remove the batteries from the user interface.
2 Cut the address jumper.
a Address jumper
NOTICE
Be careful NOT to damage any of the surrounding parts when cutting the address
jumper.
3 Turn the power supply on.
Result: The flap of the indoor unit will open and close to set the reference position.
INFORMATION
▪
For FTXF and ATXF units, the following setting MUST be completed within
5 minutes after the power supply is turned on.
▪
In case you could NOT complete the setting in time, turn the power supply off
and wait at least 1 minute before turning the power supply back on.
4 Press simultaneously:
Model
FTXF, ATXF
5 Press:
Model
Button
FTXF, ATXF
6 Select:
Model
FTXF, ATXF
7 Press:
Model
FTXF, ATXF
a
a
Buttons
,
and
Symbol
Button
FTXF20~42D5V1B + ATXF20~42D5V1B
Daikin room air conditioner
4P519439-16R – 2021.12
Advertisement
Table of Contents
