21 Configuration
In this chapter
21.1 Making field settings
21.1.1 About making field settings
RXYSA8~12AMY1B
VRV 5-S system air conditioner
4P752782-1A - 2024.02
DANGER: RISK OF ELECTROCUTION
INFORMATION
It is important that all information in this chapter is read sequentially by the installer
and that the system is configured as applicable.
21.1
Making field settings............................................................................................................................................................... 129
21.1.1
About making field settings ................................................................................................................................... 129
21.1.2
Field setting components ...................................................................................................................................... 130
21.1.3
To access mode 1 or 2 ........................................................................................................................................... 131
21.1.4
To use mode 1........................................................................................................................................................ 132
21.1.5
To use mode 2........................................................................................................................................................ 132
21.1.6
Mode 1: monitoring settings ................................................................................................................................. 133
21.1.7
Mode 2: field settings ............................................................................................................................................ 135
21.1.8
Indoor unit field setting ......................................................................................................................................... 140
21.2
21.2.1
21.2.2
Available comfort settings ..................................................................................................................................... 142
21.2.3
21.2.4
To continue the configuration of the VRV 5-S heat pump system, it is required to
give some input to the PCB of the unit. This chapter will describe how manual input
is possible by operating the push buttons on the PCB and reading the feedback
from the 7-segment displays.
Next to making field settings it is also possible to confirm the current operation
parameters of the unit.
Push buttons and DIP switches
Item
Push buttons
Description
By operating the push buttons it is possible to:
▪
Perform special actions (refrigerant charge, testrun,
etc).
▪
Perform field settings (demand operation, low noise,
etc).
21
Configuration
|
Installer and user reference guide
129