Unpacking; Accessory Box; Assembly; Assemblingthe Accessory Kit - Generac Power Systems LP Series Owner's Manual

1.1 UNPACKING
* Removeall packagingmaterial.
* Removethe generatorfrom carton.
* Removeseparateaccessory box.
NOTE:
Standard 20 poundLP cylinder(tank) is not included.
I. I. 1 ACCESSORY BOX
Checkall contents. If any parts are missing or damaged,locate an
authorizeddealerat 1-888-436-3722.
* 1 - Owner's Manual * 1 - Tank Bracket
* 0.6 - Liter Oil SAE 10W-30 * 1 - FrameFoot
* 2 - Never-Flat W heels • 1 - TankShroud
* 1 - Oil Funnel
* 1 - HardwareBag (containingthe following):
- 2-Rubber F eet - 6-M8Bolt(Long)
- 2-1/2" AxlePins - 2-M8Bolts(Short)
- 2-CotterPins - 6-HexFlanged M8Nuts
- 2-1/2" FlatWashers
Figure 1 - Accessories
1.2 ASSEMBLY
Thegeneratorrequiressome assemblyprior to using it. If problems
arise when assembling the generator, please call the generator
hetplineat 1-888-436-3722.
1.2.1 ASSEMBLING THEACCESSORY K IT
The wheels are designed into the unit to greatly improve the
portability of the generator.
You wilt needthe following tools to properly install the accessory
kit.
* NeedleNose Pliers * lOmm, 12mm, 13mm sockets
* Ratchet * lOmm, 12mm, 13mm wrenches
* 5mm Allen wrench
NOTE:
The wheels are not intendedfor over-the-road use.
1. Refer to Figure 2 and install the Wheels as follows:
- Slidethe Axle Pinsthrough the Wheel, 1/2" FlatWasher,andWheel
Bracket on the frame.
- Insert the Cotter Pinthrough the Axle Pinthen bend the tabs (ofthe
Cotter Pins) outward to lock into place.
2. Refer to Figure 2 and install the Frame Foot and Rubber
Bumpers as shown.
- Slidethe RubberBumperstuds through the Frame Footthen install
the Locking FlangeNuts.
- Slidethe HexHead Bolts through the holes in the Frame Rail.
- Slide the Frame Foot onto the Hex Head Bolts then install the
Locking FlangeNuts.
3. Refer to Figure 2 and install the Tank Bracket as shown.
- Remove the hex nuts from the lower panel on each side at the
rear.Push Flatheadbolts back for the bracketto fit and align holes
with bolts.
- Slide the long Bolts through the Tank Bracket and Cradle, then
install the HexNuts.
4. Install tank shroud as shown in Figure 2.
- Slidetab ends in betweentubes in rear of cradle.
- Insert M8 Bolts (long) through tubes and into treaded inserts.
Figure 2 - Wheel & Handle Assembly