Lincoln Electric OPTIMARC CV/CC505 Operator's Manual page 18

C-2
CAUTION
Observe all Safety Guidelines detailed in the beginning and throughout this manual.
Problems (Symptoms)
Starting arc is difficult.
The meter displays ERR 031
The meter displays ERR 032
The meter displays ERR 035
The meter displays ERR 036
The meter displays ERR 041
The meter displays ERR 082
The meter displays ERR 124
The meter displays ERR 213
TROUBLESHOOTING
If for any reason you do not understand the test procedures or are unable to
perform the tests/repairs safely, contact your local authorized Lincoln Electric
Field Service Facility for technical assistance.
Possible Areas of Misadjustment(s)
1. Verify the proper polarity is being used for the
weld procedure.
2. Check all electrode and work connections.
3. Verify the parameters of wire feeding speed,
output voltage and shielding gas are proper for
the welding procedure.
4. PC board in machine possibily at fault.
Primary over current from switchboard.
Low input line voltage error from control board.
Input voltage out of range.
Thermostat Trip.
Secondary over current from switchboard
Motor overload.
Invalid weld mode.
CAN communication error.
OPTIMARC
Recommended Course of Action
®
CV/CC505
If PC board in machine is at
fault, contact an authorized
Lincoln Electric Service facility
for technical assistance.
Contact your local
authorized Lincoln Electric
Field Service facility for
technical assistance.
Contact your local
authorized Lincoln Electric
Field Service facility for
technical assistance.
Make certain that input
voltage is proper, according
to the Rating Plate.
Clear obstruction or repair
fan;
After machine has cooled,
reduce load, duty cycle, or
both.
Contact your local
authorized Lincoln Electric
Field Service facility for
technical assistance.
Please reduce the welding duty
cycle of machine.
Please check if all the welding
procedures are correct.
Contact your local
authorized Lincoln Electric
Field Service facility for
technical assistance.
C-2
Rev. 01