Table of Contents
Advertisement
Relerences
• HandlingDiscs
• Remove
tile disc from its case by holding
it at
the edge while pressing
the center hole lightly.
• Do not touch the shiny surface
of the disc or
To clean the disc
Wipe the disc with a soft cloth in a straight line
from center to edge.
• DO NOT use any solvent -- such as
conventional record cleaner, spray,
thinner or benzine -- to clean the disc.
• Cleaning the system
bend the disc.
• Put the disc back in its case alter use to
prevent
warping.
• Be careful
not to scratch
the surface
of the
disc when placing
it back in its case.
• Avoid exposure
to direct sunlight,
temperature
extremes
and nloisture.
Stains on the system
should be wiped off with a soft cloth. If the
system
is heavily
stained,
wipe it with a cloth soaked
in water-
diluted
neutral
detergent
and wrung well, then wipe clean with a
dry cloth.
Since the system
may deteriorate
in quality,
become
damaged
or
get its paint peeled oft'. be careful
about
the following.
• DO NOT wipe it with a hard cloth.
• DO NOT wipe it strong.
• DO NOT wipe it with thinner
or benzine.
• DO NOT apply any volatile
substance
such as insecticides
to it.
• DO NOT allow any rubber
or plastic
to remain
in contact
with
it I_r a long time.
PROBLEM
POSSIBLE
CAUSE
SOLUTION
Power does not come
The power cord and/or system
cord is not connected.
Connect
the power cord and system
cord correctly.
on.
(: -" pg. 15)
The remote
control
does
The batteries
are exhausted.
Replace
the batteries.
(_ -" pg. 7)
not work.
Sunlight
is falling
directly
on the remote
sensor.
Hide the remote
sensor
from direct sunlight.
No sound.
The system
cord and/or speaker
cord is not connected.
Check the connection.
(-" pg. 15)
The audio cord is not connected
to AUDIO
IN (VCR)
Connect
the cord correctly.
(-" pg. 15)
and/or
DIGITAL
IN (DBS)
correctly.
An incorrect
source
has been selected.
Select the correct
source.
(
" pg. 19)
The decode
mode is not set correctly.
Select the proper decode
mode. (-"
pg. 37)
No picture
is displayed
The video cord is not connected
correctly.
Connect
the cord correctly.
(_ -" pg. 14)
on the TV screen.
The disc is not playable.
Use a playable
disc. (-" pg. 3)
No picture
is displayed
The scan mode is set to "PROGRESSIVE"
though
the
Change
the scan mode
to "INTERLACE".
(-" pg. 20)
on the TV screen,
the
center
unit is connected
to the TV which does not
picture
is blurred,
or the
support
the progressive
video
input such as a
picture
is divided
into
conventional
TV.
two parts.
Video and audio are
The disc is scratched
or dirty.
Replace
or clean the disc.
distorted.
A VCR is connected
between
the center
unit and the
Connect
the center unit and TV directly.
(_ -" pg. 14)
TV.
The picture
does not fit
The monitor
type is not set correctly.
Set "MONITOR
TYPE"
properly.
(-" pg. 39)
the TV screen.
Hard to listen to
Antennas
are disconnected.
Reconnect
the antennas
correctly
and securely.
broadcast
because
of
(: -" pg. 8)
noise.
45
- Quick Links:
- Connectingthe Powered Subwoofer
Hide quick links:
Advertisement
Table of Contents
