Operatingexternalcomponents W Ith The Remotecontrol; Operatingthe Tv; Operatingthe Dbstuner Or Catvconverter - JVC TH-M606 Instructions Manual

Operatingexternalcomponents w ith the remotecontrol
The buttons described below are used on pages 16 and
17.
TV/VIDEO
VCR ,-
TV VOL +/- ,2
CHANNEL +/- --
<t<1-
II-
REC ,-
TV RETURN --
TV/VIDEO
rv VC_JDB8
O0_n _ @ '_
Q O ©
O
TVVOL CHANNEL
OQ
_ % _ %
O O
D #" %
©/I VCR/DBS
0/I TV
DBS
_ Remote control
mode selector
_1_
(play button)
,_1_
-- II
ENTER
Number
buttons
,- !00+
J
J
NOTE
• Manulacturers' codes are subject Io change withoul nolice.
• Sel 1he codes again aller replacing 1he batleries of 1he remote cunlrol.
4
Press number buttons (1-9, O) to enter
the manufacturer's code (2 digits).
Examples:
For a Hitachi TV:
Press 1, then 0.
For a Toshiba TV:
Press 0, then 8.
Manufacturer Code Manufacturer
JVC 01 Samsung
Hitachi I0 Sharp
Magnavox 02 Sony
Mitsubishi 03 Toshiba
Panasonic 04, 11 Zenith
RCA 05
Code
12
O6
07
1)8
O9
,_ Release ©/I TV.
It" there is more than one code listed for corresponding brand,
try each one until you enter the correct one.
• Operation
Aim the remote control at the TV.
IMPORTANT
Before using the remote control to operate a TV;
• Set the remote control mode selector to TV.
The following buttons are available:
0/I TV: Turns TV on and off.
TV VOL +/-: Adjusts the volume.
TV/VIDEO: Selects the input mode (either TV or
VIDEO).
CHANNEL +/-: Changes the channels.
1-10, 0, +10 (100+): Selects the channel.
TV RETURN: Alternates between the previously selected
channel and the current channel.
• To set the manufacturer's code
You can operate a JVC TV without setting the malaufacturer's code.
1 Slide the remote control mode selector
to TV.
2 Press and hold ©/I TV.
Keep the button pressed until step 4 is finished.
3
Press ENTER.
• Toset the manufacturer'scode
1
Slide the remote control mode selector
to VCR/DBS.
2
Press DBS.
3
Press and hold ©/I VCR/DBS.
Keep the button pressed until step 5 is finished.
4
Press ENTER.
Continued on next page
16