Table of Contents
Advertisement
Supplying Power
1 Plug in AC Adaptor
Charge Battery Pack fully before use.
POWER Lamp lights.
2
3
Insert Battery.
Q Align lett side of Battery with left edge of
AC Adaptor.
(O) Press Battery down and slide in direction
of arrow.
The CHARGE Lamp flashes, then stays lit
when charging is complete.
3 Remove Battery
Slide Battery to the left and lift off.
Note:
* Charging takes about 1 hour.
* While the DC Power Cable (supplied) is connected
to the AC Adaptor, the Battery cannot be charged.
* After charging 5 times, use Battery Refresh feature
as explained below. `
* Battery life gradually decreases after repeated use
:
and recharging. If operation time becomes very
(Top View)
short even after a sufficient charge, discard Battery
properly (page 9).
| Using) QS Batiany Rack
A fully charged Battery provides a maximum of about 1 hour 10 minutes of continuous use.
Actual time may vary due to operating conditions.
CHARGE
Lamp
A Attach Battery.
© Insert top of Battery into top of mounting
-
surface.
BATTERY
(9 Press and snap into place.
PACK
Battery.
IB EEN
Refresh
To use battery refresh, insert Battery on AC
Adaptor (see steps 1-2 above), then press
This feature completely discharges
BATTERY REFRESH.
Battery before recharging begins. Use
The REFRESH Lamp lights, then goes out when
after every 5 charges for optimum
discharae
i
:
:
ge is complete. Battery charging will then
Battery performance.
start automatically.
If BATTERY REFRESH is pressed by mistake,
remove Battery from AC Adaptor and reinsert it
for normal charging.
Note:
* Charging takes about 5 hours when Battery
Refresh is used.
REFRESH
Lamp
BATTERY
REFRESH
* Battery will not operate in extremely high
temperatures.
8
For assistance, please call : 1-800-211-PANA(7262) or send e-mail to : consumerproductsG panasonic.com
Advertisement
Table of Contents
