Table of Contents
Advertisement
General information
service life of the product will extend and the
possibility of problems will decrease if the product
is cleaned at regular intervals.
Switch off the electricity before cleaning
appliance to avoid an electric shock.
\ DANGER
\ Hot surfaces may cause burns!
— Allow the appliance to cool down before you
clean it.
e
(Clean the product thoroughly after each use.
In this way it will be possible to remove
cooking residues more easily, thus avoiding
these from burning the next time the
appliance is used.
e
No special cleaning agents are required for
cleaning the product. Use warm water with
washing liquid, a soft cloth or sponge to clean
the product and wipe it with a dry cloth.
e
Always ensure any excess liquid is thoroughly
wiped off after cleaning and any spillage is
immediately wiped dry.
e
Do not use cleaning agents that contain acid
or chloride to clean the stainless or inox
surfaces and the handle. Use a soft cloth with
a liquid detergent (not abrasive) to wipe those
parts clean, paying attention to sweep in one
direction,
s
ne surface may get damaged by some
adetergents or cleaning materials.
Mo not use aggressive detergents, cleaning
powder/cream or any sharp objects.
#00 not use steam cleaners for cleaning.
Cleaning the hob
Glass ceramic surfaces
Wipe the glass ceramic surface using a piece of
cloth dampened with cold water in a manner as
not to leave any cleaning agent on it. Dry with a
soft and dry cloth. Residues may cause damage on
the glass ceramic surface when using the hob for
the next time.
Dried residues on the glass ceramic surface
should under no circumstances be scraped with
hook blades, steel wool or similar tools.
Remove calcium stains (yellow stains) by a small
amount of lime remover such as vinegar or lemon
juice. You can also use suitable commercially
available products.
If the surface is heavily soiled, apply the cleaning
agent on a sponge and wait until it is absorbed
well. Then, clean the surface of the hob with a
damp cloth.
,
"gougar-based foods such as thick cream and
syrup must be cleaned promptly without
waiting the surface to cool down. Otherwise,
glass ceramic surface may be damaged
permanently.
Slight color fading may occur on coatings or other
surfaces in time. This will not affect operation of
the product.
Color fading and stains on the glass ceramic
surface is a normal condition, and not a defect.
Cleaning the control panel
Clean the control panel and control knobs with a
damp cloth and wipe them dry.
»
Damage of the control panel!
1Do not remove the control knobs for control
panel cleaning.
Advertisement
Table of Contents
