Elation CHORUS LINE 8 User Manual page 7

S A F E T Y G U I D E L I N E S
• DO NOT TOUCH the fixture housing during operation.
• Turn OFF the power and allow approximately 15 minutes for the fixture to cool down before
serving.
• DO NOT shake fixture and avoid brute force when installing and/or operating fixture.
• DO NOT operate fixture if the power cord is frayed, crimped, damaged, and/or if any of the
power cord connectors are damaged and do not insert into the fixture securely with ease.
• NEVER force a power cord connector into the fixture. If the power cord or any of its connec-
tors are damaged, replace it immediately with a new one of the same rating.
• DO NOT block any air ventilation slots.
• All fan and air inlets must remain clean and never blocked.
• Allow approx. 6" (15cm) between fixture and other devices or a wall for proper cooling.
• When installing fixture in a suspended environment, always use mounting hardware that is no
less than M10 x 25 mm, and always install fixture with an appropriately rated safety cable.
• Always disconnect fixture from main power source before performing any type of service
and/or cleaning procedure.
• Only handle the power cord by the plug end, and never pull out the plug by tugging the wire
portion of the cord.
• During the initial operation of this fixture, a light smoke or smell may emit from the interior
of the fixture. This is a normal process and is caused by excess paint in the interior of the
casing burning off from the heat associated with the lamp and will decrease gradually over
time.
• Consistent operational breaks will ensure fixture will function properly for many years.
• ONLY use the original packaging and materials to transport the fixture for service.
7